For example, using a high-pass filter set at 120Hz for a single-coil bass will remove most of its low-end features, giving it a much weaker bass sound. Obviously, you have to take your instrument into consideration before removing a good chunk of frequencies. You can also try using a high-pass filter set to either 60Hz or 120Hz to cancel out most of the hum. A spectrum example of 60-cycle/Mains hum. Naturally, EQ set to any harmonic frequency of 60Hz will do a good job at cancelling out this type of noise, just make sure you use the narrowest Q possible so that your overall sound quality remains intact. And while humbuckers do a great job at cancelling out the hum at 60Hz, they are not immune to the other 60Hz intervals (such as 120Hz, 180Hz, etc.) this type of interference can also affect. Understanding 60-Cycle Hum And Its RemovalÄue to the nature of electricity here in the US (more specifically, the fact that it has a fundamental frequency of 60Hz), players are often faced with the 60-cycle hum, also known as Mains Hum. Thankfully, you can tackle this little hiccup with a bit of your own EQ work. While many audio editing programs come with plugins that help eliminate this hum, not all of them do. Luckily, there are ways to combat hum with equalization. While it is particularly unpleasant on stage, the last thing you want is for it to creep up during a recording, especially on an otherwise great take. If you haven't already experienced this type of noise before, you have more than likely heard about it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |